United States Department of Transportation

FHWA Highway Safety Programs

Safety Eligibility Letter SS-51

Hardware Type:

Sign Supports, Mailboxes, and Delineator Posts

Code:

SS-51

Date:

01/23/1995

Testing Criteria:

NCHRP 350

Manufacturer:

Unistrut Corp.

Device Description:

A570 Perforated Square Steel Posts W/60 ksi yield

View PDF:

ss51.pdf (186.86 KB)

Feedback

January 23, 1995

Refer to: HNG-14/SS-51

Mr. Herbert J. Henry
Telespar Product Manager
Unistrut Corporation
35660 Clinton Street
Wayne, Michigan 48184-2091

Dear Mr. Henry:

In your January 9 fax letter to Mr. James H. Hatton, you indicated that you wish to augment your Telespar Sign Post product offering by including posts made of ASTM A570 steel that will have a minimum yield strength of 413.69 MPa (60,000 psi). In addition, you requested the Federal Highway Administration's (FHWA) acceptance of several of these posts installed in a variety of configurations for use on National Highway System (NHS) projects. After reviewing our records of experience with similar posts we find that we can comply with your request, with some limitations.

These limitations pertain to non-acceptance of a few post sizes and to the mechanical properties of the steel used in the posts. The square perforated sign posts that we have knowledge of meeting our breakaway requirements were made of steel with mill test reports showing yield strengths ranging from 417.82 to 453.68 Mpa (60,600 to 65,800 psi), ultimate tensile strengths ranging from 474.36 Mpa to 512.97 Mpa (68,000 to 74,000 psi), and elongations over 50 mm (2 inches) of between 16 and 18 percent. Our typical acceptance letter contains a caveat that "we anticipate that the States will require certification…that the hardware furnished has essentially the same chemistry, mechanical properties, and geometry as that [tested] and that it will meet the FHWA change in velocity requirement." At the acceptance margins we believe it would be unwise for a supplier of perforated steel tube sign posts to make such a certification without confirming crash tests if the mill test reports for the steel used show ultimate tensile strengths greater than 550 Mpa (79,800 psi) or elongations over 50 mm (2 inches) greater than 20 percent. The post sizes and use conditions we will find acceptable for use on the NHS, if proposed by a State, are shown in the enclosed table.

Sincerely yours,

Jerry L. Poston, Chief
Federal-Aid and Design Division

Geometric and Roadside Design Acceptance Letter SS-51

Federal Highway Administration
HNG-14:JHatton:366-1329:gm:1-23-95:Henry
copies to: HPD-1 HNG-1 HNG-10 HNG-14 Reader, 3128 File, 3128
RAs HFL-1 HHS-10 HSR-20 HNG-12

FHWA Safety Home | FHWA Home | Feedback

United States Department of Transportation - Federal Highway Administration